大連東軟信息學院大一上 電子工程 c語言-實驗doc第一次,第二周(共6頁)

1、Lab 1Getting Started with C Programming in TurboCOBJECTIVESAfter completing this experiment, you will be able to:code C programs in TurboCcompile and run C programs in TurboCsave C programs in TurboCload C programs into TurboCbuild a simple C program in TurboCdebug simple C programs in TurboCuse hot

2、 keys of TurboCPROCEDURESPART 1 Code a C Program1. Run TurboC Development Environment.2. Use FileNew to open a new file.3. Edit a C program as follows:#include main()int a,b; a = 251; b = 8; printf(%dn, a*b);PART 2 Compile and Run a C program 1. Press Ctrl and F9 keys at the same time to compile and

3、 run a C program.If error occurs, modify the program, compile and run it again.2. Press Alt and F5 keys at the same time to switch to the user screen to get the result.If the result is not 2008, modify the program, compile and run it again.TIP：Press Esc key to return to the edit screen.Print Screen

4、of Result: 1 mark PART 3 Save a C program1. Press F2 key to save a C program.2In the input box shown below, input a file name with .c extension (e.g. first.c). 3. Press Enter key to save the file.PART 4 Load a C program1. Press F3 key to load a C program in the default path of TurboC, e.g. C:DISK_CT

5、C20, D:turboc2.2. Input the program name (e.g. first.c) to be loaded in the input box.3. Press Enter key to load the file.If error occurs, check the file name and check the default path to make sure whether the name is right and the program is over there. What is the default path of the TurboC in yo

6、ur computer? 1 markPART 5 Build a C programCreate a C program that displays your student id and name (Pin Yin) on the screen. Make differences by using Escape Sequence in table 1.2 in page 11, e.g. n, t, etc.1. Write the C program.Print Screen of Code: 6 marks2. Save it using .c extension.3. Compile

7、 and run it using Ctrl and F9 keys.4. Check result using Alt and F5 keys.5. If error occurs, modify the program, save it, recompile and run it again.Print Screen of Result: 2 marksPART 6 Debug a Simple C ProgramCopy programs error1.c，error6.c in directory “error1-6” to the default path of TurboC, lo

8、ad and debug them one by one.1. Debug error1.c and read the error prompts.Print Screen of Code: 1 mark2. Debug error2.c and read the error prompts.Print Screen of Code: 1 mark3. Debug error3.c and read the error prompts.Print Screen of Code: 1 mark4. Debug error4.c and read the error prompts.Print Screen of Code: 1 mark 5. Debug error5.c and read the error prompts.Print Screen of Code: 1 mark6. Debug error6.c and modify the program to displayPrint Screen of code: 5 marksPART 7 Use Hot Keys in TurboCCtrl + F9Compile and runAlt + F5Switch to User ScreenF2Save a programF3Loa