電加熱器說明書版

1、最新資料推薦DRK 型空氣電加熱器DRK Electric Air Heater使用說明書OperatingInstruction Manual江蘇國能環保設備有限公司Jiangsu Guoneng Environment Protection Equipment Co., Ltd.5一、 前言 PrefaceDRK型空氣電加熱器是我廠近年來研制成功的專門供燃煤發電廠除灰系統使用 的新型加熱設備，該設備由空氣電加熱器和控制系統兩個部分組成。發熱元件采用 1Cr18Ni9Ti不銹鋼無縫管作保護套管，0Cr27A17M2高溫電阻合金絲、結晶氧化鎂粉， 經壓縮工藝成型， 使電加熱元件的使用壽命得以保

2、證。 控制部分采用先進的數字電路、 集成電路觸發器、高反壓可控硅等組成可調測溫、恒溫系統，保證了電加熱器的正常 運行。DRK electric air heater, the new type heating equipment special for coal-fired power plant ash collection system, is successfully made by our company recent years. This equipment consists of electric air heater and control system. Heating un

3、it adopts 1Cr18Ni9Ti seamless steel tube as the protective case. After compression craft formation,0Cr27A17MO2 hightemperature resistance alloy wire and crystal magnesia powder could makesure the life of electric heating element. Control part uses advanced digital circuit, IC trigger and high counte

4、r voltage SCR to compose adjustable thermometer and thermostat system, which insure the normal working of heater.該產品適用于電站空氣輸送斜槽氣化風加熱，電除塵器灰斗氣化風和貯灰?guī)鞖?化風加熱等方面。This equipment use for power plant air delivery skewed slot gasification wind heating, electric dust collector gasification wind and ash storeho

5、use gasification wind heating. 技術參數 Technical Parameter1. 空氣電加熱器的規格與參數Specifications and Parameter of Electric Air HeaterModel、功率capacityKW輸入電壓input voltage V額定電流rated current每相APhase A進口溫度Inlet temp.C額定流量Rated flow m/mi n額定流量溫升Rated flowtemp.riseC最高工作 溫度 Max.working temp.C進口法蘭通徑Inlet flange drift d

6、iameter mm壓力PressureMPDRK4545380/22078-20 507.52320 300125P0.82.控制柜的主要技術指標數據 Main Technical Index Data of Control Box1) .輸入電壓 In put voltage: 380V 5%(三相四線 three phase four wiresystem)2) .額定功率 Rated capacity : 45KW3) .額定電流 Rated current : 78A(單相 single phase)4) .控溫精度 Control accuracy : 0.5 級5) .控溫范圍

7、control range : 0300C三、結構與工作原理 Structure and operating principle1. 空氣電加熱器結構 Structure of Electric Air Heater電加熱器是由多支管狀電熱元件、簡體、導流板等幾部分組成，管狀電熱元 件是在金屬管內放入高溫電阻絲，在空隙部分緊密地填入具有良好絕緣性和導熱 性能的結晶氧化鎂粉，采用管狀電熱元件做發熱體，具有結構先進熱效率高，機 械強度好，耐腐、耐磨等特點。筒體內安裝了導流隔板能使空氣在流通時受熱均 勻。The electric air heater consists of multi tubula

8、r heating element, drum, flow deflector and etc. Put the high-temperature resistance wire in the metal tube and tightly fill in the void with crystal magnesia powder, which has the high insulating property and high-thermal conductivity. The tubular heating element is a heating unit with the characte

9、ristics of advanced structure, high thermal efficiency, high mechanical strength, corrosion-resistantand wear resistance. Flow deflector, installed in thedrum, could make the air uniform heated when circulating.2. 控制工作原理 Control principle 數顯溫度控制柜采用數顯溫度調節儀，集成電路觸發器，大功率可控硅和測 溫元件組成測量、調節、控制回路，在電加熱過程中測溫元件

10、將空氣電加熱器出 口溫度電信號送至數顯溫度調節儀進行放大、比較后顯示測量溫度值，同時輸出 010V電壓信號到可控硅觸發組件的輸入端，控制輸出脈沖相位，從而控制可控 硅導通角度大小，使控制柜有良好的控制精度和調節特性。利用聯鎖裝置可遠距 離啟動、關閉空氣電加熱器。Digital display temperature cabinet uses digital display temperature regulator, IC trigger, high power SCR and temperature element to compose the measuring loop, regulat

11、ing loop and control loop. Temperature element sends the outlet temperature electrical signal of electric air heater to the digital display temperature regulator, which could indicate temperature value after amplification and comparison. Meanwhile, the digital display temperature regulator outputs t

12、he 0 10V voltage signalto incoming end of SCRtrigger assembly, in order to control outlet impulse phase. Consequently, making control box being more controllable through control thyristor operating angle,四、安裝與使用 Setup and use控制柜應安裝在干燥通風、便于操作的地方?？諝怆娂訜崞魍鈿?、控制柜外 殼應可靠接地、空氣電加熱器應水平安裝，底座螺母要擰緊使其穩固。本體與外接管道安裝時

13、，應注意進出口方向安裝測溫元件時，應區別“ +” “ - ”端接入控制柜接線端子的“ +” “- ”對應 處。加熱器在使用前應測量電源接入端子與金屬外殼的冷態絕緣電阻不得低于2MQ,使用環境相對濕度不大于85%。電源線的出、入端應牢固可靠，不得松動。使用前首先檢查電源線、測溫元件輸出聯線是否正確，控制柜元器件、螺絲 是否松動損壞，如有異常及時擰緊或更換，確認無誤后可通電試車。Cabinet should be in stalled in the dry ratio n and handy place. Shellof electric air heater and cabinet could

14、with the connection to the earth.Electric air heater should adopt horiz on tal in stallati on. Make the base nuts tighten in order to fix heater.1. 合上空氣開關（QS，電源指示燈亮，數顯表控制燈亮并顯示所測溫度指示 值。Open QS air switch, power indicator light illuminates digital displaycontrol light illuminates and indicates the tem

15、perature value.2. 溫度的設定 temperature setting:1）.溫度控制儀面板示意圖 diagram of temperature regulator panel :顯示器indicator； XMT 數顯 溫度調 節儀：XMT digital displaytemperature regulator ； 設定電位器： set pote ntiometer;指示燈：indicator light ; 切換開關：switch2）.溫度預置方法 Temperature initialization:將“切換開關K”撥向右邊“控制”，旋轉“設定電位器 W ,當順時針旋轉

16、時，溫度設定值T設增大，反之減小。溫度預置完畢，再將“切換開關K”撥至中間“測溫”，此時顯示測溫值，即T實。當T實T設時，控制指示燈亮，當T實丁設時，指示燈滅。MoveK switch to right “ control ” position and spin set potentiometer W1, when clockwise rotation, temperature setting value Tset would grow,otherwise would reduce. After temperature initialization, moving K switch to “t

17、hermometer ” position, at this momentindicates the thermometer value Tactual.WhenTactual Tset , control indicator light illuminates, otherwise control indicator light off.3 ) . 報警設定方法 alarm setting ：將“切換開關K”撥向左邊“報警”，旋轉“設定電位 W,當數值達到T設 預置完畢，再將K撥至中間“測溫處”。當T實T設時，報警指示燈滅，當T實T設時，報警指示燈亮。Move K switch to lef

18、t “ alarm ” position and spin set potentiometerW2. The initializationis finish when value arrive T 設, then move the K switchto middle “ thermometer ” position.WhenT 實T設，alarm indicatorlight off, otherwise alarm indicator lightilluminates.3. 溫度設定好之后，如無異常情況即可按下“加熱器工作”按鈕，交流接觸 器KM吸合，可控硅進線端得電，有數顯控溫表所輸出PI

19、D電信號控制空氣電加熱 器工作。開機時，可能出現溫度過沖現象，但逐漸趨向恒定范圍之內。After setting temperature, pressing the air heater operation button if there is no any abnormal. Then ACcontactor begin to work, SCRinput terminal picks up current, electric air heater start-ups via the control of PID electric signal output by the digital d

20、isplay temperature regulator. After start a short time, it may have a temperature overswing phenomenon, but tends to gradually the constant scope.五、維護與保養 MaintenanceDRK系列空氣電加熱器特別是控制部分，系精密儀器，運輸時要小心輕放， 嚴禁沖擊、撞打。簡體部分應合理吊裝，以免變形損壞內部發熱元件?？諝怆娂?熱器及控制柜存放在庫內，嚴禁淋雨。最新資料推薦DRK series electric air heaters are preci

21、sion instruments, especially the control parts. Handle with care and strictly prohibit the parts to be impacted. Hoist the drum reasonably in order to avoid damaging the internal heating unit. Electric air heater and the cabinet should be put in the warehouse, strictly prohibiting to be exposed to t

22、he rain.六、故障原因與排除方法 Failure cause and repair 故障一：電源指示燈不亮，數顯表不工作，電壓表無指示。 排除方法：檢查空氣開關是否合上，控制回路熔絲是否完好。 Failure 1: Power indicator light does not illuminate, digital display instrument does not work, pressure gauge does not indicate. Repair: Check whether air switch is off. Check whether control loop fuse is broken.故障二：加熱器溫度不上升。 排除方法：用示波器檢查觸發器有無輸出脈沖波形、數顯溫度調節儀有無 PID 信 號輸出。Failure 2: Heater temperature does not rise. Repair: Check whether trigger outputs impulse waveform by oscillogra