醫療器械GMP文件QA-OP-017 預警和忠告性通知控制程序

1、更改歷史版本號文件更改號更改概要修改人批準人01首發行/發放范圍 SCOPE 范圍This document describes the procedures to be followed when any safety alert and advisory notice is necessary to be handled. 本文件描述的程序是用于處理預警和忠告性通知發布所必須遵守的流程。PURPOSE 目的 To handle safety alert and advisory notice in time so as to avoid the re-occurrence of simil

2、ar affairs.為及時處理預警、忠告性通知，防止同類事件的再次發生。ASSOCIATED DOCUMENTS 相關文件Advisory Notice 忠告性通知書 Adverse Event Reporting Procedure 不良事件報告控制程序 Corrective & Preventive Actions Control Procedure 糾正和預防行動控制程序DEFINITIONS AND ACRONYMS 定義和縮寫 Advisory Notice of medical devices: After the delivery of medical devices, the

3、 complementary information or advisory actions issued by organization related to the aspects in usage, modification,recall and destruction of devices. 醫療器械忠告性通知：在醫療器械交付后，由組織發布的通知，在器械的使用、改動、召回、銷毀方面給出的補充信息或建議采取的措施。RESPONSIBILITIES 職責5.1 Quality dept. is responsible for the analysis, investigation, man

4、agement of quality informations, and reporting the related situation. 質量部統籌對質量信息的分析、調查、處理工作，并協調通報相關的情況。5.2 Production dept., Engineering dept., Material dept., Purchasing dept. should take part in the analysis, investigation, and management of the quality information. 生產部門、工程部、物料部、采購部參與對質量信息的分析、調查、處

5、理。5.3 Related personnel responsibility of early safety alert system refer to attachment oneSafety alert system Function matrix. 早期預警系統的各部門相關人員職責詳見附件一 “預警系統職能矩陣表”。PROCEDURE 程序Early safety alert system早期預警系統 6.1.1 If ATL recognized the delivered products couldnt reach the expected purpose and the poss

6、ibility and potential hurt will done to the patients because of some poor quality, the Engineering dept. and Quality dept. should analyze the causes and effects for the poor quality. 如本廠發現已發運后的產品未能達到預期用途及由于某種質量缺陷懷疑產品可能對病人造成傷害或潛在的傷害，由工程部及質量部對質量缺陷進行原因及影響分析。 6.1.2 Engineering dept. and Quality dept. sh

7、ould take relevant actions according to the severity degree of issues. For example, start the early safety alert system. Releasing the “Advisory Notice” to customer after approved by the management. 工程部及質量部依據問題的嚴重程度采取應的行動措施，如：啟動早期預警系統。交于管理層審批，經批準后向顧客發出“忠告性通知書”。 6.1.3 Carrying on the risk analysis af

8、ter early safety alert system started, and implementing relevant actions according to “SOP-B12-2011 Corrective & Preventive Actions Control Procedure”. 啟動早期預警系統后，要進行風險分析并按“糾正和預防行動控制程序”規定執行相應措施。Note: Pay attention to the local national laws and regulations during the process of application. 注：應用時要注意當

9、地的國家或法規的要求。 Advisory Notice忠告性通知 6.2.1 When below situations occurred, quality dept and Engineering dept. could hold a meeting for the consideration of releasing “Advisory Notice”. 當發生以下情況時，質量部、工程部召開會議研討考慮發出“忠告性通知書”。 a) Any supplement information about the usage of medical device 醫療器械在使用時應注意的補充事宜； b

10、) The modification of medical device 醫療器械的改動c) Medical device return to company or agent 醫療器械被退回公司或代理商 d) The destroy of medical device 醫療器械的銷毀 e) The recall of medical device 醫療器械需要召回 6.2.2 Advisory Notice shall include following content: 忠告性通知包括下列內容： a) The name, Lot No,specification and quantity

11、about the involved product出現問題的產品名稱、批號、規格和數量 b) The reason which lead to release Advisory Notice 發布忠告性通知的理由 c) Possible occurred hazard可能產生的危害 d) Follow up actions 隨后采取的措施 6.2.3 Engineering dept. and quality dept. are responsible for collecting relevant information, and calling for the concerned dep

12、artments to have a meeting for discussing, when the comments showed recall is unnecessary and the same effect could be reached through other ways, the detailed advisory notices should be prepared and released to customer after approved by management. 工程部、質量部負責相關資料收集，并召集相關部門開會研討，當分析討論認為不需要采取召回形式，可通過其

13、它方式處理，也可達到同樣的效果時，應編制詳細的忠告性通知書，經管理層批準后向顧客發出“忠告性通知書”。 6.2.4 Market shall confirm the distribution address, receiver and contact information of involved product according to the delivery record, inform and release D-QA035 Advisory Notices to customer or agent timely, and keep the relative releasing and

14、 following record. 市場部依照產品分銷記錄，確定需發布忠告性通知的該批產品的銷往地址、負責收貨人姓名和聯系電話等，及時告知并發放給相關顧客或代理商“D-QA035忠告性通知書”。并保持忠告性通知發布和跟蹤確認的記錄。 6.2.5 If the national or local regulation require to report advisory notice to local FDA Bureau, quality dept conduct it after approved by General Manager. 如果國家和地區法規要求本廠將忠告性通知報告給當?shù)厮幤?/p>

15、監管部門，經總經理審核批準后由質量部負責執行。6.3 If applicable, adverse event report refer to Adverse Event Reporting Procedure. 適用時，不良事件報告按“不良事件報告程序”執行。Flow Chart 流程圖 N/AAttachment 附件 Attachment One Safety alert system Function matrix 附件一：預警系統職能矩陣表人員 Personnel客戶Customer總經理General manager管理者代表Management representative項目經

16、理Project manager工程師EngineerQA員QA inspectorQE生產負責人Production responsible person 職責 Responsibility收集相關資料 Collection of relevant information客戶信息溝通（包括忠告性通知及調查表的發出及收回）Information communicated with customer(including the send and reclaim of advisory notice and investigation form)對客戶的抱怨進行評審 Review customer complaint編制忠告性通知 Compile advisory notice編制召回產品報告 Compile product recall report 產品檢驗和試驗分析Product inspection and testing analys