EN60335-2-25嵌入式微波爐的要求--By Keng

1、Deviation between build-in microwaveand portable microwave嵌入式微波爐與便攜式微波爐差異比較,Prepared by: Keng Mo (莫家鏗) Mar. 11, 2009,Welcome to the seminar,嵌入式微波爐與便攜式微波爐的差異主要體現 在: 安裝尺寸要求(說明書) 防觸電要求 測試角的要求 通風設計的要求上.,定義：,built-in appliance (嵌入式器具 ) fixed appliance intended to be installed in a cabinet, in a prepared

2、recess in a wall or in a similar location 打算安裝在廚柜內、墻中預留的壁完內或類似位置的固定式器具。,Clause 6 Classification(分類）,6.1 Electric shock protection Class I or Class II 6.2 Harmful ingress protection (IPX0),Clause 7 Marking and instructions,7.1 Marking 嵌入式與便攜式微波爐的要求一樣。 7.12 Instructions 嵌入式除了7.12.4要求不同外,其他與便攜式微波爐的要求一樣

3、。,說明書要求：,7.12.4 The instructions for built-in appliances shall include information with regard to the following: 嵌入式器具，其使用說明(書)應包括下述方面的明確信息: dimensions of the space to be provided for the appliance; 為器具提供的空間尺寸; dimensions and position of the means for supporting and fixing the appliance within this

4、space; 在此空間內支撐和固定器具的裝置的尺寸和位置;,說明書要求：, minimum distances between the various parts of the appliance and the surrounding structure; 器具各部分與其周圍安放器具的設施有關部分之間的最小間距; minimum dimensions of ventilating openings and their correct arrangement; 通風孔的最小尺寸以及它們的正確布置; connection of the appliance to the supply mains

5、and the interconnection of any separate components; 器具與電源的連接，和各分離元件的互連;,說明書要求：, necessity to allow disconnection of the appliance from the supply after installation, unless the appliance incorporates a switch complying with 24.3. The disconnection may be achieved by having the plug accessible or by

6、incorporating a switch in the fixed wiring in accordance with the wiring rules. 除非器具帶有一個符合24.3 的一個開關，否則其需有一個在安裝后用戶能進行插拔的插頭, 或者一個串聯在固定配線上的開關來斷開電源. Compliance is checked by inspection. 通過視檢,檢查其合格性。,安裝尺寸,Clause 8 Protection against access to live part,8.1 防止接觸到帶電體的要求, 通過8.1.1, 8.1.2, 8.1.3的測試工具檢查, 8.1.

7、4是對安全低電壓的判定. 8.1.5是對嵌入式,固定式器具的要求. 8.2 II類電器與II類結構的對基本絕緣的要求. 嵌入式與便攜式微波爐的要求一樣。,防觸電Clause 8.1.5,8.1.5 Live parts of built-in appliances, fixed appliances and appliances delivered in separate units, shall be protected at least by basic insulation before installation or assembly. Compliance is checked by

8、 inspection and by the test of 8.1.1. 嵌入式器具、固定式器具和以幾個分離組件形式交付的器具在安裝或裝配之前，其帶電部件至少應由基本絕緣來防護。 通過視檢，來檢查其合格性。,Clause 11 Heating,11.2 嵌入式微波爐對測試角有專門的要求, 要按照說明書的安裝要求來布置測試角. 11.3 溫升測試方法(電阻法,熱電偶法) 11.4 電熱器器具測試 11.5 電動類器具測試 11.6 復合類器具測試 11.7 測試時間確定 11.8 測試結果判定,測試角情況Clause 11.2,11.2 測試角要求 Built-in appliances ar

9、e installed in accordance with the instructions. 嵌入式器具，按說明書要求安裝. Dull black-painted plywood approximately 20 mm thick is used for the test corner, the supports and for the installation of built-in appliances. 測試角、支撐物和用于嵌入式器具安裝的設施,都使用厚度約為20mm的，涂有無光黑漆的膠合板.,Clause 13 Leakage current and electric streng

10、th at operating temperature. Clause 15 Moisture resistance Clause 16 Leakage current and electric strength Clause 17 Overload protection of transformers and associated circuits.,Clause 18 Endurance Clause 19 Abnormal operation Clause 20 Stability and mechanical hazards 20.1 嵌入式器具不要求做10或15的穩定性測試. 20.

11、2 對運動部件的防護與便攜式微波爐要求一樣.,Clause 21 Mechanical strength,21.1 機械強度(沖擊測試) 21.101鉸鏈門的開合測試(嵌入式有要求) 21.102 側鉸鏈門和底鉸鏈門測試 21.103 20mm正方體木塊對門邊的測試 21.104 門隨沖擊球的測試 21.105 底部鉸鏈門測試 21.2 可接觸絕緣材料的強度要求(材料厚度),機械強度要求 Clause 21.101,21.101 Hinged doors are positioned approximately 30 before the fully open position. Slidin

12、g doors are positioned so that they are approximately two-thirds open. A force of 35 N is applied to the inside surface of a hinged door at a point 25 mm from its free edge or to the handle of a sliding door. 21.101 將鉸鏈門打開到全開位置前約30的位置，滑動門約打開2/3,然后將35 N的力加至鉸鏈門內表面離其自由端25 mm處的一點上或滑動門手柄處。,機械強度要求 Clause

13、21.101,the force is applied by means of a spring balance having a spring constant of 1,05 N/mm. It is initially applied with an opposing force applied to the other side of the door or handle. The opposing force is then removed to allow the door to complete its travel to the fully open position. The

14、test is carried out five times. 這 一外 力 是由一彈性系數為1.0 5N /mm的彈簧工具施加的，首先以反向的力加到門或手柄的另一側，然后去掉這一反向力使門完全打開。 試 驗 進 行五次。,Clause 21.101,The test is repeated on doors of stationary appliances and built-in appliances except that the door is initially placed midway between the fully open and closed positions; th

15、e applied force is 1,5 times the force required to open the door or 65 N, whichever is greater. However if the force cannot be measured or if the door is opened indirectly, the 65 N force is applied. The test is carried out five times. 在駐 立 式 微波爐和嵌裝式微波爐的門上重復試驗，但試驗條件改為： 門 的初始狀態置于全開和關閉的中間位置； 施 加的力是打開門

16、所需力的1.5倍或65 N，取其較大者，如果該力無法測量或門已間接地被打開，則用65N的力 試 驗 進 行五次(打開門),Clause 21.101,Doors are placed midway between the fully open and closed positions. A closing force of 90 N is applied to the outside surface of a hinged door at a point 25 mm from the free edge or to the handle of a sliding door, initially

17、 with the opposing force as described above. This test is carried out 10 times. The appliance shall then comply with Clause 32. 將 門 置 于全開和關閉的中間位置，用一個90N 的關門力施加在鉸鏈門外表面離自由端25m m處或加在滑動門的把手上，開始時是用上述的相反的力。 試 驗 進 行10次。(合上門) 器 具 應 符合第32章的要求。,Clause 22 Construction,Part I 通用部份(22.1-22.52) Part II 嵌入式除22.101

18、有特別要求外,其他都與便攜式相同 22.101 嵌入式器具對通風的要求 22.102 通風設計對電氣間隙和爬電距離的要求 22.103 開啟至少有兩個門聯鎖裝置(開關)要求 22.104 門聯鎖切斷電路的要求(磁控管或電源) 22.105 至少有一個隱蔽的門聯鎖要求 22.106 門聯鎖監控的要求 22.107 電氣或機械的單一故障不能引起門聯鎖裝置失效要求,Clause 22 Construction,22.108 門聯鎖應在微波過量泄漏前應啟動的要求 22.109 紙片對門密封的測試要求 22.110 殘余食物對門密封的測試要求 22.111 門邊角變形對微波泄漏的要求 22.112 溫度

19、傳感器跌落不影響微波泄漏要求 22.113 可拆卸部件拆除后不影響微波泄漏的要求 22.114 在開門狀態下,單一故障(基本絕緣失效/導線松脫)不能引起磁控管工作. 22.115 對觀察窗口的要求.,22.101 Built-in appliances shall only be vented through the front, unless provisions are made for venting through a duct. Compliance is checked by inspection. 22.101 嵌裝式微波爐只能從前面開孔，除非是設計成通過管道排風的開孔。 通 過

20、 視 檢來檢查是否合格。,Clause 22.101,排氣通風孔,Clause 23 Internal wiring Clause 24 Components Clause 25 Supply connection and external flexible cords Clause 26 Terminals for external conductors Clause 27 Provision for earthing Clause 28 Screws and connections Clause 29 Clearances, creepage distances and solid insulation Clause 30 Resistance to heat and fire Clause 31 Resistance to rusting Clause 32 Radiation, toxicity and similar hazards,常見問題：嵌入式微波爐通風不良影響壽命 很多消費者將微波爐嵌入櫥柜，在使用不久后，就發現微波爐出現“質量”問題，待將微波爐修好或是重新購買一個新的微波爐后，再使用一段時間，同樣的“質量”問題再次上演，百思不得其解。殊不知這一切都是通風不良惹的禍。 解決辦法：櫥柜預留足夠空間保證通風順暢 櫥柜在設計階段，消費者就應該提前購