EPS線條安裝步驟

1、精品文檔EPS線條安裝步驟：安裝側面圖：第一步： 將特制膠漿與特制水泥所調制的混合物按 1.5:1 之比例配合，攪拌均勻后稱為特制粘貼膠漿（或使用高分子益膠泥） 。The special mucilage and special cement mixture of the modulation by 1.5:1 the proportion coordination, stir called special paste mortar (oruse the polymer cement)第二步：清潔好安裝基面，不可有任何雜質，在墻體預定上水泥鋼釘（間距700mm左右）以防在安裝過程中構架滑落。C

2、lean good installed base, do not have any impurity, in wall scheduled on cement steel nail (spacing 700 mm or so) in case in the installation process frame slide.第三步：按實際需要的長度切割構建，切割完畢后，立即拼湊核對。在拼湊。1 歡迎下載精品文檔處，露出泡沫面的地方涂抹上粘貼膠漿或高分子益膠泥。迅速拼接好。According to the actual needs of the length cutting constructio

3、n, cutting, immediately upon the completion check together. In the piece together place, revealing the foam place daub paste mortar or polymer profit cement. Rapid together again.第四步：將構件背面涂上粘貼膠漿，立即安裝。利用水泥釘固定不動（ 2-4 小時），輕推調整構件位置，確保校直所有銜接處，拼湊整齊。Will the back member with paste mucilage, immediately ins

4、tallation. Use of masonry nail fixed (2-4 hours), jog adjustment member position, ensure straightening all join place, piece together neatly第五步：多余的特制水泥膠應該用刮刀或者膩?zhàn)拥冻?，污跡應用濕布或者毛剔除去。如有表面破損，應涂抹上特制水泥砂，再用 60 硬度砂紙打磨，保證構件表面毫無缺陷。Extra special cement should use the scraper or putty knife to remove, smudges application wet cloth or hair to eliminate. If there is a surface damage, should daub special cement sand, reoccupy 60 hardness sanding, ensure the component surface without defec